返回首页

保定大型充气玩具厂

本站导航

新闻动态

当前位置:网站首页 > 新闻动态 > 详细信息
充气玩具的修补
添加时间:2019/8/29 14:57:42     浏览次数:
1、粘贴要求
1. Paste Requirements
先在玩具要粘贴处和布料上均匀涂抹胶水,然后晾至半分钟,把布样贴到粘贴处,压平后不翘边,粘贴完毕.
First, evenly apply glue on the toy sticker and cloth, then air it for half a minute, paste the cloth on the sticker, press it flat, then do not warp the edge, and paste it.
玩具被划破
The toy was scratched.
a、划口长于5cm 应用针线缝接,然后用布条或布样粘贴
A. The cut length is 5 cm. Needle and thread should be sewn and then pasted with cloth strips or samples.
b、划口小于5cm直接粘贴即可
B. The scratch is less than 5 cm and can be pasted directly.
2、接缝开线
2. Seam opening
先用针线把开口处缝接平整,(或从气垫底部拆开进入并缝接),可用粘贴的方式把开口处处理牢固,同时考虑美观
Firstly, sew the opening smoothly with needles and threads (or remove it from the bottom of the air cushion and sew it). The opening can be firmly handled by pasting, while considering the beauty.
3、美化处翘边 用小刷子在翘边处涂抹适量胶水,稍停后压平压紧,粘贴牢固即可。
3. Beautify the warping edge with a small brush on the warping edge smear appropriate amount of glue, after a little stop, press flat and press, stick firmly.
上一页  充气水滑梯的适用场地  
下一页  充气玩具分类(2)
  • 关于我们
  • 新闻动态
  • 案例展示
  • 网上订单
  • 联系我们
  • 产品分类1
  • 产品分类2
  • 产品分类3

Copyright © 技术支持:遨游网络

  • 联系我们
  • 网上订单
  • 工程案例
  • 本站导航

搜索

  • 关于我们
  • 新闻动态
  • 案例展示
  • 网上订单
  • 联系我们
  • 产品分类1
  • 产品分类2
  • 产品分类3