| 充气玩具修补 |
| 添加时间：2020/7/13 14:33:55 浏览次数： |
| 充气玩具修补 Inflatable toy repair 1、粘贴要求 1. Pasting requirements 先在玩具要粘贴处和布料上均匀涂抹胶水，然后晾至半分钟，把布样贴到粘贴处，压平后不翘边，粘贴完毕. First, apply glue evenly to the place where the toy is to be pasted and the cloth, and then let it hang for half a minute. Paste the cloth sample to the place where it is pasted. After flattening, the edge will not be warped 玩具被划破 The toy was scratched a、划口长于5cm 应用针线缝接，然后用布条或布样粘贴 a. If the cut is longer than 5cm, it should be sewn with needle and thread, and then pasted with cloth strip or cloth sample b、划口小于5cm直接粘贴即可 b. If the cut is less than 5cm, paste it directly 2、接缝开线 2. Seam opening 先用针线把开口处缝接平整，(或从气垫底部拆开进入并缝接)，可用粘贴的方式把开口处处理牢固，同时考虑美观 First, sew the opening with needle and thread (or take it apart from the bottom of the air cushion and sew it). The opening can be treated firmly by sticking, and the beauty should be considered at the same time 3、美化处翘边 用小刷子在翘边处涂抹适量胶水，稍停后压平压紧，粘贴牢固即可。 3. For the warped edge of beautification part, apply proper amount of glue on the warped edge with a small brush, press it flat and press it after a short time, and then stick it firmly. |
| 上一页 充气玩具一般的分类 |
| 下一页 儿童充气玩具安全注意事项 |
Copyright © 技术支持：遨游网络